C Type Universal Seals ONLY - for Standard Continuous Sleeve Gear Coupling Types (C, CFR, CMM, CSPCR, CSHP, etc)

For use with all Standard Lovejoy Continuous Sleeve Gear coupling types (C, CFR, CMM, CSPCR, CSHP, etc).

Note: Seals are included in Continuous Sleeve Gear Coupling Accessory Kits, and are generally not ordered as a stand alone item.

Unit of Measure

Specifications

Description 

N/A C 3 SEAL

Type

N/A Universal Seals

Hub Material

N/A Steel

Color

N/A Metallic

Coupling Type

N/A Gear

Weight

N/A 0.19 lb

Complete Coupling Weight

N/A 33.00 lb

Dimensional Data

Height

N/A 9.000 in

Depth

N/A 0.500 in

Dimension HL

N/A 12.000 in

Cubic inches

N/A 54.00000 in³

Dimensional Data of Related Coupling

Overall Length

N/A 5.500 in139.70 mm

Outside Diameter

N/A 6.630 in6.63 mm

Size

N/A 3

Max. Bore (Dimensions ID1/ID2)

N/A 3.13 in84.00 mm

Dimension CBD

N/A 4.750 in120.65 mm

Dimension DC

N/A 0.250 in6.35 mm

Dimension HD

N/A 4.750 in120.65 mm

Dimension HL

N/A 2.630 in66.80 mm

Dimension LS

N/A 3.750 in95.25 mm

Dimension R

N/A 6.880 in174.75 mm

Dimension SL

N/A 1.880 in47.75 mm

Distance between Shaft Ends (Dimension G)

N/A 0.250 in6.35 mm

Distance between Shaft Ends (Dimension G1)

N/A 0.750 in19.05 mm

Performance Data

Normal Temperature Range

N/A -40 to 212 ºF

Performance Data of Related Coupling

Nominal Torque

N/A 50400.00 in·lb

Max. Speed (Unbalanced)

N/A 3600.00 rpm

Parallel Misalignment

N/A 0.010 in

Max. Angular Misalignment

N/A 0.50º per Mesh

Features

Features 

N/A
  • Simple and inexpensive type of gear coupling
  • All steel sleeves and hubs
  • Reinforced rubber seals with snap rings to hold lubricant in place
  • Available as vertical and horizontal couplings
  • Wide variety of special variations such as full-flex, flex-rigid mill motor
  • Standard configurations are available of the shelf

Notes

Notes 

N/A
  • Puller Holes are standard on sizes 4 through 12.
  • Puller Holes are available for sizes 7/8 through 3.5 at an additional charge.
  • The BSE (distance Between Shaft Ends) may vary between G and G1.
  • Interference bores with no set screws are standard unless otherwise specified.
  • Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
  • For metric bores and keyway tolerances, consult Lovejoy Engineering Section.
  • Larger sizes are available, please consult Lovejoy Technical Support.